Analogue Productions THE ULTIMATE ANALOGUE TEST LP (Plattenspieler Abdeckung), Plattenspieler Zubehör

Hochwertige audiophile Test LP von Analogue Productions U.S.Die bekannte Test LP des amerikanischen Qualitätsherstellers Acoustic Sounds. Hohlen Sie alles aus Ihrem Plattenspieler, Tonarm und Tonabnehmer heraus. TitelGeneral Reference LevelTrack 1 - 1kHz Reference Tone 8cm/s lateral in phase (mono)This 1 kHz reference tone will allow you to establish a "base level" for all measurementsAzimuth AdjustmentTrack 2 - 1kHz reference level, left channel onlyMeasure right channel outputTrack 3 - 1kHz reference level, right channel onlymeasure left channel outputHigh Frequency Adjustmenttracks 4,5 and 6 are used to calibrate the RIAA high frequency equalizer of a phono preamp. This will be used to calibrate a mastering lathe's phono preamplifier or any phono preamplifier that has these adjustmentsTrack 4 - 1kHz tone at -20db below reference level, lateralTrack 5 - 10kHz reference tone at -20db, lateralTrack 6 - 1kHz to 20 kHz sweep at -20db, lateralLow Frequency Adjustmenttracks 7 and 8 are used to calibrate the RIAA low frequency equalizer of a phono preampTrack 7 - 1kHz to 20Hz sweep at 0VU, lateralTrack 8 - 100 Hz reference tone at 0VU, lateralTrack 9 - VTA adjustThis is an IEC intermodulation distortion (IMD) test signal. Using an IMD tester, adjust VTA by raising or lowering the tonearm for minimum distortionTrack 10 - Standard Wow & Flutter test signal, 3150HzThe Wow & Flutter meter will give dynamic speed variations as a percentage deviation from nominalSeite 2Track 1 - Anti-Skating test, 315Hz amplitude sweeptrack 2 and 3 are used for cartridge demagnetizingTrack 2- Pink noise lateralTrack 3 - Pink noise verticalTrack 4 - 1kHz at reference level, verticalThis out-of-phase signal should cancel to nothing when summed to mono. Any signals still present are distortion artifacts, lack of channel balance, or timing (phase) anmoalies. This test can be a second confirmation of anti-skate adjustmentTrack 5 - 1kHz to 10Hz sweep at -20db below reference level, verticalResonance anomalies in the tonarm/cartridge interface will show up as amplitude peaks and dips as the frequency sweeps down.Track 6 - Silent Groove for bearing rumbe and table isolationDuring playback of this track, nothiing should be transmitted from the turntable to the speakers. Replay the track and gently tap on the rack or base that the turntable ist resting on. There shoulb be little or no thump transferred to the speakers. This track will help you experiment with turntable isolation methods and products to be able to get the most out of your playback system. You may want to use a closed or sealed headphonoe for best listening results, or a stehoscope on the plinth.Technik Produced - Clark Williams und Barry WolifsonCut - Sterling Sound auf Neumann VMS-80 mit neu aufgebautem SX-74 SchnittkopfPressed - RTI U.S.A.